How do I hook up my TV to an Outdoor Antenna

0

How do I hook up my TV to an Outdoor Antenna

0
Share.

Hook up your TV to an outdoor antenna without the cost of hiring a contractor. The picture quality of your television relies on how well your antenna receives its signal. Indoor antennas work well in areas where the television signal is strong, but reception deteriorates if tall buildings block the signal or if your home is in a valley. Connecting your television to an outside antenna can improve reception and allows you to put your set in locations where indoor antennas can’t receive a signal.


Step One

Drill the fixing points for the antenna pole bracket at the chosen location with the drill and masonry drill bit. Push wall anchors into the drill holes and secure the bracket with 5/16-inch masonry screws. Slide the antenna pole into the “U” bolt and secure with the nuts supplied and an adjustable wrench. Attach the antenna to the antenna pole following the instructions provided.


Step Two

Connect the RG6 coax cable to the antenna and tighten the coax connector with an adjustable wrench as brands of connectors vary in size. Twist the coax around the antenna pole with one complete turn per foot and secure with electrical tape. Fix to the exterior wall with cable clips spaced 1 foot apart. Keep the coax as straight as possible.


Step Three

Attach a grounding wire to the antenna pole’s ground connector. If the pole has no ground connector, loosen a nut on the antenna pole “U” bolt and wind the wire around the thread before re-tightening. Keep the grounding wire running as straight as possible to the grounding block.


Step Four

Drill the antenna cable's entry point into the building with the drill and masonry or wood bit, depending on the material being drilled. Make the entry point as close to the television as possible.


Step Five

Secure the coax grounding block to the exterior wall as close to the antenna cable's entry point as possible. Attach the coax to the lower connector with an adjustable wrench. Make a 3-inch loop in the coax to prevent rainwater collecting at the connection. Screw the ground wire to the grounding point with a screwdriver.


Step Six

Attach the second section of coax to the top mounting point on the grounding block and feed through an RG6 weather bushing, then into the drilled entry point. Push in the weather bushing.


Step Seven

Connect a grounding wire to the grounding block, pushing it through the grounding point connector hole. Tighten the securing screw. Use No. 10 copper grounding wire and connect to the building’s central ground.


Step Eight

Connect the internal coax to the television’s “RF in” connector and tighten with your fingers.


Share.
Share.

Leave A Reply

By continuing to use the site, you agree to the use of cookies. Full Cookie Disclosure...

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close