How to make Garden Lanterns from old tin cans

0
Share.

Light up the night re-using old tin cans. That summertime, rustic appeal will add warmth and a glow to any balmy Summer evening. All you will need are tin cans (of any size), leaves to use as a pattern and a hammer and nails.


Step One

Clean up the tin can. Open each tin can and remove the top (along with any contents). Remove labels and wash with warm soapy water. Dry completely. Discard any cans that are damaged or rusted.


Step Two

Fill the tin can up to 3/4 of its length with sand. This will prevent bulging of the tin can when frozen. (Water expands when it freezes.) Add water.


Step Three

Place the tin can inside the freezer. Wait until the water freezes. Then remove the tin from the freezer.


Step Four

Choose a suitable leaf to place on tin can. Tape the leaf in place on the can. Check that you like the placement and size before you begin to hammer. Tap the first nail into the leaf, being careful not to rip or break the leaf. Consider hammering the first nail toward the top of the leaf to stabilize your design.


Step Five

Hammer the remaining nails around the perimeter of the leaf in order to create a pattern. Space the nail holes evenly so your design appears symmetrical.


Step Six

Remove the nails and pull or tear off the leaf to expose the design. You should be able to see the same leaf pattern now outlined in nail holes on the tin can.


Step Seven

Spray paint the can after you’ve created the design, so that you don’t disturb the paint (painting beforehand may create a more rough exterior).


Step Eight

Allow the tin can to dry for up to 24 hours. However, most spray paints will dry within 3 hours if left in a cool, dry area. Fill the bottom of the can with sand. Fill it with about a ½ cup of sand, depending upon the can size.


Step Nine

Place the votive in the middle of the can, resting on the sand.


Step Ten

Light the votive. (Or, turn on battery operated votive.) This will light up the night. Finished.


Share.

Report PostPost Reported

Leave A Reply