How to fix Solar Lights?

0

How to fix Solar Lights?

0
Share.

Solar lights use a small photovoltaic panel. When the sun shines on them, electricity is generated, storing power in a small battery bank. When a solar light fails to light up, there are a couple of reasons for this. It only takes a few minutes to get your lights up and running again.


Step One

Unscrew any screws on the underside of your solar light.


Step Two

Remove the glass. You may need to unscrew the glass to remove it.


Step Three

Clean the glass or casing in hot, soapy water.


Step Four

Locate the batteries under the top of the unit.


Step Five

Remove the battery cover, if there is one. You may need to unscrew this.


Step Six

Clean the battery ends and terminals. You can remove any rust or corrosion with sandpaper. Remove any bugs and dirt.


Step Seven

Test the batteries with a battery tester or a volt meter on a low DC setting. If the batteries are fine, it is probably a faulty photocell. The photocell is a light sensor that controls when the solar lights turn on or off.


Step Eight

Remove the old batteries and replace with new ones, if necessary. You will need to place the solar light in direct sunlight for at least two or three days to charge the batteries.


Step Nine

Place black electrical tape or duct tape over the photocell at night. If the light comes on, the solar light is probably too close to other light source.


Step Ten

Remove the other light source, or keep the black tape over the photocell, but only partially. This will still allow some of the light to come in.


Share.
Share.

Leave A Reply

By continuing to use the site, you agree to the use of cookies. Full Cookie Disclosure...

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close