How to build a Mini Solar Cell

0

A solar cell is the fundamental component of all solar power system. A solar panel is composed of many rows of solar cells. The solar cell is the device that converts energy from the rays of the Sun into electricity. Building mini solar cells is a simple and inexpensive way to explore solar power, whether as a science project or as the groundwork for a homemade solar panel.


How to build a Mini Solar Cell

0
Share.

A solar cell is the fundamental component of all solar power system. A solar panel is composed of many rows of solar cells. The solar cell is the device that converts energy from the rays of the Sun into electricity. Building mini solar cells is a simple and inexpensive way to explore solar power, whether as a science project or as the groundwork for a homemade solar panel.


Step One

Clean one of the stove burners well, using sandpaper, steel wool or the wire brush to scrub off any corrosion, oil, grease or other substances.


Step Two

Cut the copper flashing with the tin snips into two rectangular pieces that can each fit completely over the stove burner.


Step Three

Wash the copper flashing pieces well with soap or household cleanser and rinse completely. Brush with sandpaper, steel wool or the wire brush to remove all traces of corrosion. Dry the pieces well. Wash your hands with soap and water and rinse well to remove all grease and oils.


Step Four

Lay one of the copper rectangles, or plates, on top of the stove burner and turn the burner on to the highest setting. Set the other copper plate aside. As the plate on the burner heats up, two types of copper oxide will start to form: a reddish-orange layer of cuprous oxide, covered by a black layer of cupric oxide. After about 30 minutes from the time that the black layer has completely covered the cuprous oxide layer, turn off the heat.


Step Five

Let the copper plate cool completely. The copper will shrink as it slowly cools and much of the black cupric oxide waste will separate and flake off. After about 20 minutes, when the plate has cooled completely, remove it from the burner.


Step Six

Carefully clean the plate with the sandpaper, steel wool or wire brush, rubbing lightly and running under tap water to remove the cupric oxide while leaving behind as much of the cuprous oxide as possible.


Step Seven

Place the copper plate in the glass jar, bending it slightly toward one wall of the jar, with the cuprous oxide-coated side facing outward. Take the clean copper plate and set it in the jar, bending it toward the opposite side. With both plates in place, adjust them so they are not touching.


Step Eight

Secure the two copper plates to their respective sides of the jar with the alligator clip leads of the microammeter, connecting the negative terminal to the plate containing cuprous oxide and the positive terminal to the clean plate.


Step Nine

Dissolve the table salt completely in a heat-safe container of hot tap water and carefully pour the saltwater mixture into the glass jar, being sure not to get the alligator clips wet. Leave about an inch of space above the water line so you can adjust the copper pieces without wetting the clips.


Share.
Share.

Leave A Reply

By continuing to use the site, you agree to the use of cookies. Full Cookie Disclosure...

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close