How to reset your boiler using the reset button – Error codes E110, E119, E130, E133

0

How to reset your boiler using the reset button – Error codes E110, E119, E130, E133

0
Share.

How to reset your Baxi Group boiler using the rest button on your boiler.

Open the pull down panel to revel the controls revelling the flashing red lockout light constantly flashing or illuminated. This indicates your boiler has locked out due to certain circumstances.

To reset the boiler press the reset button until the red light  disappears.

If your timer is calling for heat, the burner light will come on to indicate the boiler has fired up and is heating your system.

If this lockout occurs frequently a fault is indicated and you should your installer or service engineer.

Afterwards place the plastic cover at the bottom of your boiler back on.

If this lockout occurs frequently a fault is indicated and you should your installer or service engineer.

Fault codes requiring a boiler reset can include:

  • E110, E130 -Which are displayed when overheat of the primary water or flue system has occurred.
  • E133 – In very cold weather E133 can often arise from a frozen condensate pipe.
  • E119 – Which is displayed when the primary water pressure is less than 0.5 bar.

A rest can be tried for any of these lock-outs.

If your boiler displays any other fault code or in the event of a reset not being successful you should make a note of the error code and contact your installer or serviced engineer for assistance.


Blog Uploaded: 26th October 2015


Share.
Share.

Comments are closed.

By continuing to use the site, you agree to the use of cookies. Full Cookie Disclosure...

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close