How to finish MDF

0

How to finish MDF

0
Share.

MDF is an inexpensive composite wood product formed from wood fibres and resin bonded under heat and pressure. It is used more than any other product for kitchen cabinets, where it is often veneered, but it has many other uses, many of them requiring only a paint, oil stain or urethane finish.


Step One

Finish raw and unprimed MDF with an oil-based stain and then a high-quality floor wax. An architect friend who develops low-cost housing often uses MDF rather than hardwood on floors. This is a stunning finish that looks expensive but isn't. One word of caution: Any time you are finishing MDF with a transparent product, do not sand the MDF before application. The result will inevitably be blotchy. Also, never apply MDF directly over floor joists; it will sag. Always apply over a subfloor.


Step Two

Finish MDF with an oil-based paint. While you sometimes see recommendations for a water-based paint on MDF, an oil-based paint will penetrate the MDF without dissolving the bond between wood fibre and resin and will seal it better. Usually two coats will suffice. It is unnecessary and inadvisable to sand the MDF before applying the first coat. After the first coat dries, sand it lightly, then apply the second coat. If there are areas where the second coat is still penetrating into the MDF (these areas will have a matt finish), apply a third coat.


Step Three

Apply an oil-stain, with or without a finishing wax, on MDF used for cabinets. Some cautions apply: Do not use an oil-based stain alone in areas that will be exposed to water, such as under a sink. Over time water will penetrate the MDF and it will disintegrate. After these problem areas are oil stained, apply a high-quality urethane. If you don't like the gloss of many urethane finishes, a semigloss and a matt finish are available.


Step Four

Finish MDF with a clear urethane. A gloss finish is most durable, but both semigloss and matt urethanes are available and will wear well.


Step Five

Apply an oil-stain first, then use a clear urethane to finish the entire cabinet. Be sure to let the oil-stain dry thoroughly so that the oil-stain and the urethane don't interact. You can also varnish MDF, although the rationale for varnishing rather than oil-staining, its increased durability, is less compelling today than before the widespread availability of urethanes. In most cases where durability is an issue a urethane will have a similar appearance and will last longer.


Step Six

Apply urethane, paint or varnish to small areas with a brush. Cover larger areas with a roller; however, if you use a roller with urethane to cover larger areas, such as floors, it will leave small bubbles that will dry into the medium. These are relatively inconspicuous. For the highest-quality finish, spray urethane or apply it with a special-purpose applicator available at most home-improvement stores. Sometimes these can be rented. The applicator is basically a large wiper that comes with its own tray, and it will ensure that the urethane does not bubble when applied.


Share.
Share.

Leave A Reply

Inline
Inline

By continuing to use the site, you agree to the use of cookies. Full Cookie Disclosure...

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close