How to tile a bathroom

0

Tile is a popular floor and wall covering in bathrooms where surfaces need to resist water and moisture. A little more expensive than linoleum for floors or fiberglass for shower walls, tile increases the value of a home and adds a quality look. Installing tile in your bathroom is a project you can complete on your own, with the right tools and preparation.


How to tile a bathroom

0
Share.

Tile is a popular floor and wall covering in bathrooms where surfaces need to resist water and moisture. A little more expensive than linoleum for floors or fiberglass for shower walls, tile increases the value of a home and adds a quality look. Installing tile in your bathroom is a project you can complete on your own, with the right tools and preparation.


Reinforce the subfloor before installing floor tile. The commonly accepted method is to smooth a layer of thin-set mortar on the floor, covering it with backer board before it sets. Use screws to fasten the backer board down. This provides a solid secure surface for the tile.


Begin in the center of your room when laying the first tiles. Snap two chalk lines as guides. The first should be halfway from the longest wall, running parallel to that wall, in the exact center of your room. The other chalk line should run perpendicular to the first between the adjacent walls. Using your longest wall as a guide will reduce the effect of an uneven floor area.


Spread an even layer of thin-set mortar on the floor at your starting point, keeping a portion of the chalk line visible for reference. Use the notched edge of the trowel to spread the thin set approximately 1/4 inch thick.


Place the starter tile at the corner of your guidelines, and maneuver it by pushing into place on top of the mortar. Put spacers on each side (if desired) and add more tiles, keeping them even with the existing tiles and with the guidelines.


Continue until you reach the edge of the wall. Measure and cut the outside tiles to fit using the tile saw. A wet saw is superior to a dry saw since it reduces the heat generated by the saw blade, preventing tile dust and chipping. Wait 24 hours for the tiles to set before grouting.


Mix grout according to package directions. You can use a sanded grout or a non-sanded grout although sanded grout is normally used for floors and non-sanded grout for walls. Use a grout float to spread the grout between tiles. Let grout sit 20 to 30 minutes, then wipe off the excess with a damp sponge or cloth. When grout is completely dry, wipe tiles with a dry cloth to remove any grout haze. Wait 24 hours and apply a grout sealer according to package directions to prevent stains.


Share.
Share.

Leave A Reply

By continuing to use the site, you agree to the use of cookies. Full Cookie Disclosure...

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close