Those who love gardening know choosing the water pump is one of the most challenging things that they could do when it comes to watering the garden with high-pressure water. There are lots of things that one can do to get the best out of these pumps. However, the first step is to choose one that is most suitable to fit your needs.
If you have already installed a pump and you want to boost its performance, this article is for you:
1. Reduce the number of cycles per hour of the pump:
For reducing the number of cycles per hour, it is important to make sure that there is a balance between the influence rate and discharge rate. If the influence rate is higher, it will fill the pit faster than the motor can discharge it. To avoid this problem, try to use the pump which size is proportionate with the influence rate.
You can also increase the size of the basic to achieve the desired outcomes. However, it is important to bear in mind that this technique can be expensive.
2. Install a lift:
There should be a lift system installed which can lift the pump. Many people use the power cord for lifting the pump which is not a good idea especially when you are using the submersible pump. The power cord is not a durable method for pulling the pump.
3. Do maintenance:
Just like any other machine, the water pump used in the garden also needs repairing and maintenance to work for a longer duration. You should give your water pump regular maintenance every 6 months. After every 6 months, you should pull the pump to check the impeller and oil of the pump. This maintenance saves a lot of cost of the person as the problems are rooted out before they rear their heads.
4. Use a pipe of appropriate size:
When the velocity of the water pump is low, there is a high chance of pipe wearing out. However, when you choose a pipe that is proportionate to the size of the pump, the velocity of the motor increases that results in a long life of the piping system. The velocity of the pump should be higher if there are also some solids present in water to be moved. The concentration of these solids in liquids also decides that with which velocity a pump should rotate.
It is important to note that if the velocity of the pump does not cope with the concentration of solids in wastewater, it will result in clogging of pipes and the piping system will collapse soon. If the pipe is undersized, it will result in less flow and more clogging. If the pipe is oversized, it will need more velocity. Therefore, keep a fine balance between the size of the pipe and velocity of the pump.