Typically cut and molded with the help of high-powered electrical saws, granite presents a stubborn challenge for hand tool carvers. Since much of the mineral make-up of granite is quartz crystal, steel hand tools cannot scratch or cut the material and will quickly get ruined, while “bonded diamond” blades (a special diamond dip reserved for soft stone) will only last a few minutes against granite’s sturdy surface. For consistent and reliable results, hand tool users must first chisel the surface of a given section of granite before proceeding with a diamond-tipped handsaw in order to make deep and consistent cuts in the stone.
Step One
Designate a work surface of sufficient lighting for the chiseling and cutting of your granite section. Clear the area of any excess dirt, dust, or debris and place each tool within easy reaching distance.
Step Two
Position the granite section directly in front of you so that it is clearly visible, clean the surface of any debris, and measure the desired lengths and cuts that you wish to make. Add an extra 1/6 of an inch for the chisel and saw blade width and mark the measurements with your wax pencil in a straight line with the help of a ruler.
Step Three
Put on your safety goggles and gloves and position the carbide-tipped point chisel directly in the top edge of your marked line–this should be at one of the edges of the granite section. Hold the grip of the chisel with the point resting against the granite and, with your other hand, gently tap the head with the mallet.
Step Four
Chisel a groove at least 1/2 inch in depth at this corner. Next, chisel marks directly along the straight line you drew across your granite section. Ensure that your chisel marks are in a perfect line and continue until you have chiseled at least six inches along the line from the end of the granite.
Step Five
Place the chisel and mallet aside and insert the blade of your diamond-tipped handsaw into the groove you made with your chisel. Cut the granite with a sawing motion until you have successfully cut the entire section, wetting the blade as desired to cut down on dust accumulation.
Step Six
Continue until the entire line of the granite is cut with the handsaw. Using the point chisel or an electric diamond-wheeled grinder, finish the granite into a polish and finished shape as desired.