Most modern cars are equipped with spray nozzles in front of the windshield which are intended to spray windshield washer fluid. When a new car rolls off the lot, its spray nozzles should be properly aimed at the windshield. Over time, though, these nozzles may stray from their factory position, and they may spray the fluid in less than ideal directions. Fortunately, adjusting them is a quick and easy job.
Step One
Sit in the driver's seat and use the dashboard controls to spray some windshield washer fluid. Watch the direction of the streams carefully so that you can determine how you want to adjust them.
Step Two
Pull the hood release lever, then open the hood and prop it up with the support arm. Look at the underside of each nozzle to see if there is an adjustable nut, which not all vehicles have. If there is an adjustable nut, loosen it with the adjustable wrench. Close the hood.
Step Three
Try to turn the nozzle housings from side to side with your fingers. If there was no nut to loosen in the previous step, they may not move. If they do move, turn them in the direction they need to go, then get back in the car and spray some fluid to test the aim. If necessary, continue adjusting them and testing them until the housings are pointed in the right general direction. When you're done, re-tighten the adjustable nut if you found and loosened it in the previous step.
Step Four
Adjust the nozzles within the nozzle housings if it is necessary and possible. There are two ways to adjust the nozzles. You can grab the nozzle tip with a pair of needle nosed pliers to move it, or you can insert a needle into the nozzle hole and use that to move it around. In either case, be very careful when you do this, because not all spray nozzles can be adjusted in this way. You should be able to tell by looking at the nozzle whether it can be adjusted like this, because the nozzle will appear to be coming out of a round plastic ball. These designs are like a ball and socket joint; the nozzle is the ball and the nozzle housing is the socket.