How to do a safe water change in a freshwater aquarium

0

How to do a safe water change in a freshwater aquarium

0
Share.

Regular water changes are an important part of keeping fish in the home. Doing so reduces the harmful levels of ammonia and nitrates in the water created naturally by fish. In the wild, these levels are regulated normally. However, in the enclosed environment of a freshwater aquarium, it is necessary to do water changes to ensure that the fish can enjoy a long, healthy life.


Step One

Remove any lighting or lid on top of the tank to provide best access to the tank. Unplug any heating elements.


Step Two

Remove any artificial decorations and plants, and clean all sides of the aquarium using an algae brush, algae magnet, or algae sponge.


Step Three

Unplug any filters and take the filter pads, along with the artificial plants and decorations to a tub or sink.


Step Four

Clean the filter pads, plants, and decorations. If water has difficulty passing through the filter pad, replace it with a new one. During this time, any debris that had been stirred up will have settled into the gravel.


Step Five

Dip the larger end of the gravel siphon into the tank, with the hose now in the 5 gallon (18.9 L) bucket. Begin suction by either allowing the tube end to fill up with water and then moving it up and down in the water, or by sucking on the end of the hose until water begins flowing into the bucket. Push the gravel cleaner into the gravel at a 45° angle until you hit the bottom of the tank. Begin in a corner and drag the cleaner along the bottom of the tank slowly. Any debris that is heavier than the gravel should enter the cleaner and be sucked into the bucket. Continue to do this across the bottom of the tank. Concentrate on high-traffic areas where fish tend to rest or gather.


Step Six

Stop when you have removed 25-30% of the water in the tank. Removing too much at once can shock the fish.


Step Seven

Take the temperature of the water in the tank, then go to the spigot and adjust the water temperature to match. Adding water of a different temperature can unnecessarily stress the fish, leaving them prone to fish diseases like Ich.


Step Eight

With one end of the hose now in the tank, begin running water back into the aquarium. If a spigot is not available, use a smaller bucket to fill the aquarium. While the tank is filling, add the appropriate amount of de-chlorinator if you have chlorine in your water source. If using a bucket, add the de-chlorinator to the water before pouring it into the aquarium.


Step Nine

Replace decorations and reconnect the filter.


Step Ten

Plug in the heater and restart the filter. Hang-on-back filters (HOBs) may require a few cups of water from the tank to allow the motor to begin siphoning water again.


Share.
Share.

Leave A Reply

By continuing to use the site, you agree to the use of cookies. Full Cookie Disclosure...

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close