How to Make Remotes for RC Helicopters

0

How to Make Remotes for RC Helicopters

0
Share.

Make remotes for RC helicopter by following this easy step by step guide. Fly through the air and perform stunts based on instructions from the joystick and controls on the remote. If you damage the remote beyond repair, you can use a new one that matches the same frequency as the receiver attached to the helicopter. The receiver controls the servos in the helicopter that rotate the gears, making the helicopter blades spin.


Purchase a receiver and controller that have two operating frequency crystals with frequencies that match each other. You can match the frequency by the numbers on the tab attached to the crystals.


Remove the screws from the back of the remote control with the screwdriver. Install one operating crystal into the cover of the remote control by lining the pins up with the pin holder openings. Reattach the remote cover by tightening the screws.


Install the second crystal into the receiver. Push the crystal into the pin holder openings on the receiver housing.


Connect the receiver to the servo lines on your helicopter. Push the servo connectors into the receiver ports on the right side. Each port is marked with a number that corresponds to the remote control's switches, dials or joysticks, depending on which type of remote control you purchase.


Connect the battery to the receiver by pushing the connector into the receiver's battery port at the top. Attach the receiver securely to the RC helicopter so it's not in the way of moving parts.


Share.
Share.

Leave A Reply

By continuing to use the site, you agree to the use of cookies. Full Cookie Disclosure...

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close